voteklion.blogg.se

1. #120 VOLT WATER WELL BLADE DESKCONNECT GENERATOR#
2. #120 VOLT WATER WELL BLADE DESKCONNECT MANUAL#
3. #120 VOLT WATER WELL BLADE DESKCONNECT CODE#

X-RAY EQUIPMENT VIA NEGRELLI 55, TEL 0039 -FAX 0039 039464819 LISSONE (MONZA-BRIANZA) – ITALY THIS DOCUMENT HAS BEEN PREPARED AND DISTRIBUTED BY MECALL srl TECHNICAL PUBLICATIONS DEPARTMENT.ĪDDRESS INQUIRES REGARDING THIS DOCUMENT TO: FAILURE TO COMPLY WITH THE FOREGOING MAY RESULT IN SERIOUS OR FATAL BODILY INJURIES TO THE OPERATOR OR THOSE IN THE AREA.

#120 VOLT WATER WELL BLADE DESKCONNECT GENERATOR#

DO NOT REMOVE FLEXIBLE HIGH VOLTAGE CABLES FROM X-RAY TUBE HOUSING OR HIGH TENSION GENERATOR AND/OR ACCESS COVERS FROM GENERATOR UNTIL THE MAIN AND AUXILIARY POWER SUPPLIES HAVE BEEN DISCONNECTED. LIVE ELECTRICAL TERMINALS ARE DEADLY BE SURE LINE DISCONNECT SWITCHES ARE OPENED AND OTHER APPROPIATE PRECAUTIONS ARE TAKEN BEFORE OPENING ACCESS DOORS, REMOVING ENCLOSURES PANELS, OR ATTACHING ACCESSORIES. ONLY PROPERLY TRAINED AND QUALIFIED PERSONNEL SHOULD BE PERMITTED ACCESS TO ANY INTERNAL PARTS. PERFORM A SURVEY AFTER EVERY CHANGE IN EQUIPMENT, WORKLOAD, OR OPERATING CONDITIONS WHICH MIGHT SIGNIFICANTLY INCREASE THE PROBABILITY OF PERSONS RECEIVING MORE THAN THE MAXIMUM PERMISSIBLE DOSE EQUIVALENT.ĭIAGNOSTIC X-ray SYSTEMS MECHANICAL - ELECTRICAL WARNING ALL OF THE MOVABLE ASSEMBLIES AND PARTS OF THIS EQUIPMENT SHOULD BE OPERATED WITH CARE AND ROUTINELY INSPECTED IN ACCORDANCE WITH THE MANUFACTURER’S RECOMMENDATIONS CONTAINED IN THE EQUIPMENT MANUALS. INSTALLATION AND ENVIROMENT EXCEPT FOR INSTALLATIONS REQUIRING CERTIFICATION BY THE MANUFACTURER PER FEDERAL STANDARDS, SEE THAT A RADIATION PROTECTION SURVEY IS MADE BY A QUALIFIED EXPERT IN ACCORDANCE WITH NCRP 102, SECTION 7 OR IEC RELATED GENERAL AND COLLATERAL STANDARD AS REVISED OR REPLACED IN THE FUTURE. FAILURE TO OBSERVE THESE WARNINGS MAY CAUSE SERIOUS OR FATAL BODILY INJURIES TO THE OPERATOR OR THOSE IN THE AREA. 49 “ STRUCTURAL SHIELDING DESIGN AND EVALUATION FOR MEDICAL X-RAYS AND GAMMA-RAYS OF ENERGIES UP TO 10 MEV “ AND IEC-407 “ RADIATION PROTECTION IN MEDICAL X-RAY EQUIPMENTS 10KV - 400KV “ AS REVISED OR REPLACED IN THE FUTURE.

#120 VOLT WATER WELL BLADE DESKCONNECT CODE#

THOSE AUTHORIZED TO OPERATE, PARTICIPATE IN, OR SUPERVISE THE OPERATION OF THE EQUIPMENT MUST BE THOROUGHLY FAMILIAR AND COMPLY COMPLETELY WITH THE CURRENT ESTABILISHED SAFE EXPOSURES FACTORS AND PROCEDURES DESCRIBED IN PUBLICATIONS, SUCH AS: SUBCHAPTER J OF TITLE 21 OF THE CODE OF FEDERAL REGULATIONS, “ DIAGNOSTIC X-ray SYSTEMS AND THEIR MAJOR COMPONENTS “, AND IEC 60601 GENERAL AND COLLATERAL STANDARDS AS REVISED OR REPLACED IN THE FUTURE THOSE RESPONSIBLE FOR THE PLANNING OF X-RAY AND GAMMA-RAY EQUIPMENT INSTALLATIONS MUST BE THOROUGHLY FAMILIAR AND COMPLY COMPLETELY WITH: NCRP NO. ADEQUATE PRECAUTIONS MUST ALWAYS BE TAKEN TO AVOID EXPOSURE TO THE USEFUL BEAM, AS WELL AS TO SCATTERED RADIATION RESULTING FROM THE PASSAGE OF RADIATION THROUGH MATTER. THE USEFUL AND SCATTERED BEAMS CAN PRODUCE SERIOUS OR FATAL BODILY INJURIES TO ANY PERSON IN THE SURROUNDING AREA IF USED BY AN UNSKILLED OPERATOR. THIS DOCUMENT HAS BEEN ORIGINALLY DRAFTED IN ENGLISH LANGUAGE.ĭIAGNOSTIC X-ray SYSTEMS RADIATION WARNING X-RAY AND GAMMA-RAYS ARE DANGEROUS TO BOTH OPERATOR AND OTHERS IN THE VICINITY UNLESS ESTABLISHED SAFE EXPOSURE PROCEDURES ARE STRICTLY OBSERVED.

OTHER PERSONNEL NOT EMPLOYED BY NOR DIRECTLY AFFILIATED WITH MECALL TECHNICAL SERVICES ARE DIRECTED TO CONTACT THE LOCAL MECALL OFFICE OR DEALER BEFORE ATTEMPTING SERVICE PROCEDURES. THE INSTALLATION AND SERVICE OF EQUIPMENT DESCRIBED HEREIN IS TO BE PERFORMED BY AUTHORIZED, QUALIFIED MECALL PERSONNEL.

WHILE YOU MAY HAVE PREVIOUSLY USED EQUIPMENT SIMILAR TO THAT DESCRIBED IN THIS MANUAL, CHANGES IN DESIGN, MANUFACTURE OR PROCEDURE MAY HAVE OCCURRED WHICH SIGNIFICANTLY THE SAFE USE OF THE UNIT.

#120 VOLT WATER WELL BLADE DESKCONNECT MANUAL#

TO THE USER OF THIS MANUAL: THE USER OF THIS MANUAL IS DIRECTED TO READ AND CAREFULLY REVIEW THE INSTRUCTIONS, WARNINGS AND CAUTIONS CONTAINED HEREIN PRIOR TO BEGINNING THE USE OF THE UNIT. REVISIONS TO THE EQUIPMENT SUBSEQUENT TO THE DATE OF MANUFACTURE WILL BE ADDRESSED IN USER MANUAL UPDATES DISTRIBUTED BY THE MECALL SERVICE ORGANISATION. NOTICE THE INSTRUCTIONS CONTAINED IN THIS MANUAL CONFORMS WITH THE CONFIGURATION OF THE EQUIPMENT AS OF THE DATE OF MANUFACTURE. Corrigenda: number of the section of reference Updated with general reviewing and Integrated Console

X-RAY EQUIPMENT VIA NEGRELLI 55, TEL 0039 -FAX 0039 039464819 LISSONE (MONZA-BRIANZA) – ITALIA ĬLISIS EXEL SERVICE MANUAL MODIFICATION HISTORY Rev.